Drilling holes where you will need to start each cut will make carving easier. This way, the hard work is done, and you have a nice starting point for each cut. Make sure you make the most of your carving tools by sawing with them, this is how they are meant to be used. Pumpkin carving is time consuming; expect to spend awhile on this project if you want it to look good when you are done. Pay close attention to your pattern as you cut, you don’t want to end up losing track of the final goal and accidentally sawing off a vital connector area.
When the hard work of carving the pumpkin is done, you might want to spend a few minutes working to make it last as long as possible. Place the pumpkin in a tub full of cold water, let the pumpkin fill with water and sink. Let it soak for at least a couple of hours. Add a little bleach to the tub of water to help prevent molding. This process sounds strange, but it works to firm up the pumpkin. When you remove the pumpkin from the water, let it dry off and then rub Vaseline along any cut edges. This traps the water in the pumpkin, which is what you want, because when water escapes this is what causes pumpkins to shrivel.
Check back soon for part four of this blog.
This blog is brought to you by
dialysis jobs.
No comments:
Post a Comment